6-2 Maintenance
kina40e 06.fm technical handbook(1007)
The fine filters at the probe tip are firmly built into the filter holder. To replace the filter
holder please:
1 Unscrew the filter holder from the probe tip
2 Screw on a new filter holder.
Replacement filter holders are available for order in sets of 20 pieces as
Cat. No. 511-027.
The fine filters at the bottom of the sniffer tip are firmly built into the filter cartridge.
To exchange the filter cartridge please:
1 Loosen the screw at the bottom of the sniffer tip and detach the sniffer tip from the
probe handle
2 Take off the filter cartridge from the bottom of the sniffer tip
3 Place a new one on the two ends of the measurement and reference line
4 Attach the sniffer tip back onto the probe handle and retighten the screw at the
bottom of the sniffer tip.
Replacement filter cartridges are available for order in sets of 20 pieces as Cat. No.
511-018.
5 Exchanging the air filter at the bottom of the housing.
The air filter at the bottom of the housing should be replaced once it has turned dark
gray or deposits of dirt are clearly visible on the filter.
1 Switch off the HLD5000 off and pull the mains plug
2 Unscrew the screws in the middle of the filter
3 Remove the filter and depending on how dirty it is either replace it or clean it (for
example with compressed air or a brush)
4 Insert the filter once more
5 Tighten the screw
Replacement air filters are available for order as Cat.No. 200 000 086.
Before exchanging any of the sniffer line filters please switch off the HLD5000.
When replacing filters please make sure that no particles enter into the intake
opening.
Before replacing the air filter at the bottom of the housing please disconnect the
HLD5000.
To Next Page
Loading...
Need help?
General
