0-6 General Safety Precautions
kina40e IVZ.fm technical handbook(1007)
Failure to observe the following precautions could result in damage to the
equipment:
Danger of electric shock.
• Don’t touch live parts with the sniffer tip.
• Test samples need to be disconnected from electricity before leak testing.
To replace the fuses remove the mains cord first.
Avoid contact of the HLD5000 with bases, acids or solvents and also avoid
exposure to extreme climatic conditions.
Before loosening the connecting nut, you must switch off the HLD5000 first. When
exchanging the sniffer tip make sure that no dust or particles of dirt enter into the
opening.
The HLD5000 will only operate after having connected the sniffer line first.
Do not place the HLD5000 on hot surfaces.
During warm-up the sniffer tip must not be inserted in the test leak opening.
Otherwise, the internal calibration will be disabled and an error message will be
displayed.
To Next Page
Loading...
