21
20
3. SETTING UP THE PRINTER
3-1. SETUP
This chapter describes, how to set up the printer
1. Turn on the printer.
2. Press Enter( ) button.
3. Press Enter( ) button then enter the password.
5. If password is entered correctly, you see:
6. Press Up(▲) / Down(▼) button to select Setup Menu and press Enter( ) button
4. Press Up(▲) and Enter( ) button in the sequence of , ▲, ▲, ▲,
3-1-1. Stock PWR
Using this Menu, you can set stock type. This printer uses two kinds of stock, Standard and
High Power. Standard supports tag, label, or receipt and High Power supports linerless and
synthetic
1. In Setup Menu, select StockPWR.
2. Select stock type.
3. You see:.
4. Press any key to exit. Set Values is stored.
NOTE
The “special” setting is reserved for future supply types. Do not use this setting.
To Next Page
Loading...
General