informs LK-P12 - Printer

To Next Page

To Previous Page

▶

Press Up(▲) button

[Move cursor. (+00)]

Press Down(▼) button

[Character is changed]

Press Enter( ) button.

[Exit after stored.]

First position(+00) It changes +/-.

Store the setting and

then exit.

Second position(+00) Changes second position.

Third position (+00) It changes third position.

3-1-4. Printer

In this Menu, you can set Print Contrast, Print Positions and use of various sensors.

In this Menu, you can adjust print contrast.

1. Select Setup Menu – Printer – Contrast.

Above key operations are described in following table.

2. Press Up(▲) button to move the cursor one step towards right side (selecting the +/-).

Press Down(▼) button to change the positive/negative setting.

3. Press Up(▲) button to move the cursor one more step to the right.

Press Down (▼) button to increase/decrease the print contrast setting (0 – 9).

**Adjusting the Print Contrast

4. If you exceed the minimum/maximum range then following Menu appears and you must set

the print contrast within the acceptable range.

1. Select Setup Menu-Printer-Supply Pos

3. Above key operations are described in following table.

4. When to set, if you set exceeding minimum/maximum range then following Menu

appears on the upper part and then returns to Setting Menu again.

This Menu sets how much the paper is fed during printing.

**Adjusting the Supply Position

2. In following picture, if Up(▲) button is pressed then position of cursor moves towards

right side by one step. And if Down(▼) button is pressed then the level of character on

which the cursor is presently positioned is increased. For example, if you press on + then

it changes to -/If it is pressed on – then it is changed to +, if it is pressed on gure(Number)

then the gure increases by 1(0~9). If it becomes the data desired by user then store it and

exit by pressing Enter( ) button.

▶