3. Key in Admin password then press [Enter]
4. Press 6 or use [F2] to scroll down till Security is highlighted
5. Press 4 or use [F2] to scroll down to highlight Admin Menu PWs
and press [Enter]
6. Press [F2] to scroll down to highlight the Associated Parameter and
press [Enter]
7. Select which password (1- off, 2- Supervisor, 3- Manager, 4-
Admin, 5- Clerk) you want to use for protection of the selected
Admin menu option
Reports Menu Password Protection
All menu options in the Reports menu can be password protected and
can be configured at the terminal level.
Reports menu options will be configured to prompt for an Administrator,
Manager, Supervisor, or Clerk password. Reports Menu options that are
set up to be password protected will not require entry of a User Name.
The application will accept the required password and any qualified
higher level passwords as shown in the Password Hierarchy.
The table below shows a list of the Reports menu options that can be
password protected and the associated parameters.
The password protection screen will be presented to the user upon
accessing one of the above Reports Menu options from the Reports
Menu.
1. At idle menu press [.,#*] for the Admin menu
2. Key in Admin name then press [Enter]
3. Key in Admin password then press [Enter]
4. Press 6 or use [F2] to scroll down to highlight Security
5. Press 5 or use [F2] to scroll down to highlight Reports Menu PWs,
press [Enter]
To Next Page
Loading...
Need help?
General
