6. Press [F2] to scroll down to highlight the Associated Parameter and
press [Enter]
7. Select which password (1- off, 2- Supervisor, 3- Manager, 4-
Admin, 5- Clerk) you want to use for protection of the selected
Report menu option
Transaction Password Protection
All transactions, regardless of tender type, can be password protected
and can be configured at the terminal level.
Transactions that are set up to be password protected will not require
entry of a User Name. The transaction will be configured to prompt for
an Administrator, Manager, Supervisor, or Clerk password. The
application will accept the required password and any qualified higher
level passwords as shown in the Password Hierarchy.
The table below shows a list of the transactions that can be password
protected and the associated parameters.
The password protection screen will be presented to the user upon
initiating a transaction
1. At idle menu press [.,#*] for the Admin menu
2. Key in Admin name then press [Enter]
3. Key in Admin password then press [Enter]
4. Press 6 or use [F2] to scroll down till Security is highlighted
5. Press 3 or use [F2] to scroll down till Main Menu PWs is
highlighted, press [Enter]
6. Press [F2] to scroll down to highlight the Associated Parameter and
press [Enter]
7. Select which password (1- off, 2- Supervisor, 3- Manager, 4-
Admin, 5- Clerk) you want to use for protection of the selected
Main menu option
To Next Page
Loading...
Need help?
General
