Ingenico Link/2500 - Config Menu Screen

Page 30
Link
/
25
00 User Guide
Copyright© 2019 Ingenico
To access the Config menu press the button twice, then choose
SUPERVISOR and press button. You will be asked to type your current
supervisor code, and confirm this by pressing the button, and choose
CONFIG.
Below is a summary of the functions within the Config menu and how to access
them, and what they do.
Some Supervisor functions MUST only be used when instructed
to do so by the terminal Helpdesk.
First Config Menu Screen
PRINT EMV
Prints EMV data loaded on the terminal. Do not
use this feature unless instructed to do so by
the terminal Helpdesk.
PRINT CERTS
Prints Certificates loaded on the terminal. Do
not use this
feature unless instructed to do so
by the terminal Helpdesk.
PSTN PREFIX
Allows the telephone network (PSTN) prefix
number to be set.
GSM N/W
TEST
Prints a rolling data sheet of the mobile
network. Do not use this feature unless
instructed to do so by the terminal Helpdesk.
SEL GSM N/W
Allows
the selection of a different mobile
network. Do not use this feature unless
instructed to do so by the terminal Helpdesk.