Ingersoll-Rand 302 SERIES - Quick Menu Key Functions

22
Quick Menu Key Functions
Pressing [Quick Menus] The list indicates the different
areas contained in the Quick menu.
Select My Personal Menu to display the chosen personal
parameters. These parameters are selected in par. 0-25
Personal Menu. Up to 20 different parameters can be
added in this menu.
Select Quick setup to go through a limited amount of
parameters to get the motor running almost optimally.
The default setting for the other parameters considers the
desired control functions and the configuration of signal
inputs/outputs (control terminals).
The selection of parameter is effected by means of the
arrow keys. The parameters in the following table are
accessible.
Parameter
Designation
Setting
0-01
Language
1-20
Motor Power
[kW]
1-22
Motor Voltage
[V]
1-23
Motor Frequency
[Hz]
1-24
Motor Current
[A]
1-25 Motor Nominal Speed [rpm]
5-12
Terminal 27 Digital Input
[0] No function*
1-29
Automatic Motor Adaptation
(AMA)
[1] Enable complete
AMA
3-02
Min Reference
[rpm]
3-03
Max Reference
[sec]
3-41
Ramp 1 Ramp-up Time
[sec]
3-42
Ramp 1 Ramp-down Time
[sec]
3-13
Reference Site
* If terminal 27 is set to “no function”, no connection to
+24 V on terminal 27 is necessary.
Select Changes made to get information about:
the last 10 changes. Use the [▴] [▾] navigation
keys to scroll between the last 10 changed
parameters. •
the changes made since default setting.
Select Loggings to get information about the
display line read-outs. The information is shown
as graphs.
Only display parameters selected in par. 0-20
and par. 0-24 can be viewed. It is possible to
store up to 120 samples in the memory for later
reference.