EasyManuals Logo
Home>INIM Electronics>Control Panel>SmartLine Series

INIM Electronics SmartLine Series User Manual

INIM Electronics SmartLine Series
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10 General information
Conventional fire detection control panel
Note:
The detached notes contain important information about the text.
Attention:
The attention prompts indicate that total or partial disregard of the procedure could damage
the connected devices.
Danger:
The danger warnings indicate that total or partial disregard of the procedure could injure the
operator or persons in the vicinity.
2.11 Menu paths
Example
From panel: <key>, Programming, Progr. zone, select a zone, Ok
Via software application: Control panel, Zones
Access to specific functions can be achieved by using the panel keys or PC video objects and the respective path.
Note:
This manual describes the recommended programming flow.
Attention:
For most part this manual describes programming from the control panel.
2.12 CE Mark
Figure 2 - Certifications for SmartLine control panels
Note:
The indications for the CE marking shown in the installation manual of the SmartLetLoose/ONE electronic
board (optional accessory device) are an integral part of the indications shown here on condition that it is
installed in the mentioned control panels.
Declarations of performance, declarations of compliance and certificates relating to the products mentioned
in this manual can be downloaded from the following website:
www.inim.biz
0051
EN 54-2:1997 + A1:2006
EN 54-4:1997 + A1:2002 + A2:2006
EN 54-21:2006
SmartLine020-2
Control and indicating equipment with integrated power supply
equipment and alarm transmission and fault warning routing
equipment for fire detection and fire alarm systems installed in
buildings
INIM ELECTRONICS S.R.L.
via Dei Lavoratori 10 - fraz. Centobuchi
63076 Monteprandone (AP) - Italy
18
0051-CPR-1414
0051
EN 54-2:1997 + A1:2006
EN 54-4:1997 + A1:2002 + A2:2006
EN 54-21:2006
SmartLine036-4
Control and indicating equipment with integrated power supply
equipment and alarm transmission and fault warning routing
equipment for fire detection and fire alarm systems installed in
buildings
INIM ELECTRONICS S.R.L.
via Dei Lavoratori 10 - fraz. Centobuchi
63076 Monteprandone (AP) - Italy
18
0051-CPR-1412
0051
EN 54-2:1997 + A1:2006
EN 54-4:1997 + A1:2002 + A2:2006
EN 54-21:2006
SmartLine020-4
Control and indicating equipment with integrated power supply
equipment and alarm transmission and fault warning routing
equipment for fire detection and fire alarm systems installed in
buildings
INIM ELECTRONICS S.R.L.
via Dei Lavoratori 10 - fraz. Centobuchi
63076 Monteprandone (AP) - Italy
18
0051-CPR-1413
Essential characteristics Performance
SSAPPerformance under fire conditions
SSAPPerformance of power supply
Response delay (response time to fire) PASS
SSAPPerformance of transmission
SSAPOperational reliability
Durability of operational
reliability:
temperature resistance PASS
vibration resistance PASS
SSAPelectrical stability
humidity resistance PASS
Options provided according to EN 54-2 Performance
7.8 Output to the fire alarm device PASS
7.9 Control of fire alarm routing equipment PASS
SSAP eticsu elled odratiR 11.7
7.12 Dependencies on more than one signal (Type A and B) PASS
SSAPTest condition 01
Essential characteristics Performance
SSAPPerformance under fire conditions
SSAPPerformance of power supply
Response delay (response time to fire) PASS
SSAPPerformance of transmission
SSAPOperational reliability
Durability of operational
reliability:
temperature resistance PASS
vibration resistance PASS
SSAPelectrical stability
humidity resistance PASS
Options provided according to EN 54-2 Performance
7.8 Output to the fire alarm device PASS
7.9 Control of fire alarm routing equipment PASS
SSAP eticsu elled odratiR 11.7
7.12 Dependencies on more than one signal (Type A and B) PASS
SSAPTest condition 01
Essential characteristics Performance
SSAPPerformance under fire conditions
SSAPPerformance of power supply
Response delay (response time to fire) PASS
SSAPPerformance of transmission
SSAPOperational reliability
Durability of operational
reliability:
temperature resistance PASS
vibration resistance PASS
SSAPelectrical stability
humidity resistance PASS
Options provided according to EN 54-2 Performance
7.8 Output to the fire alarm device PASS
7.9 Control of fire alarm routing equipment PASS
SSAP eticsu elled odratiR 11.7
7.12 Dependencies on more than one signal (Type A and B) PASS
SSAPTest condition 01

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the INIM Electronics SmartLine Series and is the answer not in the manual?

INIM Electronics SmartLine Series Specifications

General IconGeneral
BrandINIM Electronics
ModelSmartLine Series
CategoryControl Panel
LanguageEnglish

Related product manuals