Installation and programming manual
Maintenance 65
1. Press Ok to activate/deactivate the output.
2. Press or to go to the adjacent output.
15.8Set the date for the next maintenance session
From panel with the jumper inserted:<key>, Maintenance, Maintenance date, Ok
If you have set the date of the next maintenance session, the system
will signal a fault event on the specified date. Only a new date,
selected via this menu, will clear this fault signal.
15.9Reading the power supply tension
From panel with the jumper inserted:<key>, Maintenance, Power level, Ok
The display shows the output voltage of the power supply module
housed in the control panel.
This function is useful during the calibration of the charging voltage
described in paragraph 6.17 - Thermal probe.
Maint. Fault
01/01/18 18:23
Monday
To Next Page
Loading...
