Installation and programming manual
Closing the programming session 61
Chapter 13
Closing the programming session
Once you have completed the programming, remove the panel/PC programming jumper. The panel will be
ready to go into service, and the display will be as follows.
Double check the functionality of all the input devices.
13.1 Restoring factory settings
From panel: <key>, Programming, Factory data, Ok
If you select this option, you will access the "Confirm" screen. If you press Ok (working from this screen)
all the programming data (panel and extinguishant module) will reset to default values (factory settings).
Control panel
In service
01/01/18 18:23
To Next Page
Loading...
Need help?
General
