25
Section 5: System Operation
This section of the manual explains how to start the device, operate it, and
turn it off.
Prior to using or connecting the Applicator, inspect the System
and Applicator for possible mechanical damage.
5.1 Device Start-Up
1. Connect the Applicators to the harness.
2. Turn on the Main Power switch on the Rear Panel.
3. Press the On-Off button on the Control Panel to turn the device on.
The System loads the software and enters the Login Screen.
4. Enter a unique password to get access to the device. If password is
correct the system enters the Menu Screen.
5. The system loads the software and enters a self-test mode. If any
problem is detected during the test the error message will appear
(See the Troubleshooting section in this manual). If the test is passed
correctly, then the System automatically enters the Menu Screen.
6. Select Application from the Menu Screen and the System will enter
the Treatment Screen.
7. Verify on the screen that the software version is properly displayed,
and that the connected Applicator type is recognized correctly.
8. Select the treatment parameters using up and down arrow keys.
9. Press the Start Button to activate the treatment.
5.2 System Shutdown
▪ To shut down the System, turn the On-Off switch located at the front to
Off (Figure 5.2).
▪ Turn the Main Power switch located at the backside of the System to
Off at the end of the day (Figure 5.1).
To Next Page
Loading...
