46
10. The belt should not be loose. Ensure the belt is taut around the
treatment area. Secure the units with additional belt on the top if
needed.
11. Up to 8 Applicator units can be applied to the treatment area. Tight
Applicator units around the treatment area with a belt to assume
good coupling between electrodes and skin.
12. Activate the treatment by entering Active mode.
13. Slight erythema and edema is a typical immediate response.
However, when there is an excessive skin response (erythema and
edema) or strong discomfort level, stop the treatment.
The skin should be observed for excessive erythema or edema. If
observed, stop the treatment and move to the next treatment
zone.
8.7 Treatment Schedule
The number of treatment sessions depends on the individual patient and is
typically 6 weekly sessions but can be as short as 3 at longer treatment
durations.
Treatment should be concluded when the results are satisfactory to the
patient or according to the physician's discretion.
One session every ~3months, or as needed, may maintain treatment
results.
8.8 Post-treatment Recommendations
▪ Skin cooling is NOT recommended.
▪ The patient should avoid very hot water for 2 days after the treatment.
▪ The patient should avoid scrubbing, pinching and etc. of the treated
area.
▪ Moisturizer and makeup may be applied to the skin surface
immediately post treatment.
▪ After each treatment session, the patient should be advised to contact
the physician if there is any indication of infection, excessive swelling,
redness, pain, or any other unusual or untoward symptom.
▪ The Applicator should be cleaned and disinfected by 70% alcohol.
To Next Page
Loading...
