34
The skin should be observed for excessive erythema or edema. If
observed, stop the treatment and move to the next treatment
zone.
The treatment recommendations for the EvolveX System with the
Transform Applicator in EMS-TENS mode are as follows:
1. Ensure that skin is clean and dry.
2. Follow Device Start-Up from Section 5.1.
3. Always start with a low setting level to check the patient’s tolerance
to the treatment parameters. Increase the settings gradually to see
muscle contraction.
4. Thin layer of conductive gel should be applied to the treated area or
directly to the Applicator electrodes.
Prior to using the conductive gel, ensure that the gel container has
not passed the expiration date.
5. Power level to be set according to patient tolerance, starting at 5
intensity level and increasing gradually.
6. Apply applicators to the treated area and tight with the belt to
ensure good coupling.
7. Set treatment time and press the "On" icon to start the treatment.
Slight erythema and edema are a typical immediate response.
However, when there is excessive tissue reaction, stop treatment.
For excessive heat sensation, you may decrease the intensity of
pulses.
6.8 Treatment Schedule
▪ The number of treatment sessions in RF mode depends on the
individual patient and is typically 6 weekly sessions but can be as short
as 3 at longer treatment durations. One session every ~3months, or as
needed, may maintain treatment results.
▪ The number of treatment sessions in EMS/TENS mode is 4-10 sessions,
once or twice a week but can vary according to patient response.
▪ Treatment should be concluded when the results are satisfactory to the
patient or according to the physician’s discretion.
To Next Page
Loading...
