InMode EVOLVE X - Section 10: Troubleshooting; 10.1 Description of Faults with All Applicators

Evolve System Operator Manual
Section 10: Troubleshooting
48
Section 10: Troubleshooting
The EvolveX System provides monitoring of all critical parameters to ensure
safety of patient and user. If any of the following faults are detected system
automatically goes to Stand By mode.
10.1 Description of Faults with All Applicators
Problem
Description and Checks
System did not turn on
▪ Check power cord connection.
▪ Check that main switch on Rear Panel is on.
▪ Check that On/Off switch on Front Panel is on.
▪ Check fuses on the Back Panel of the System.
▪ Call Technical Service if the problem persists.
System shuts down by
itself
▪ Check power cord connection.
▪ Check fuses on the Back Panel of the System.
▪ Call Technical Service if problem persists.
Checksum
▪ The software was not loaded properly from
software plug.
▪ Check the plug connection and reboot the
System.
▪ Call Technical Service if the problem persists.
The connected Applicator
is not recognized
▪ Check connection of the Applicator.
▪ Replace the Applicator.
▪ Call Technical Service if the problem persists.
Fault H8005, H800F,
H8010 – System Memory
Fault
Call Technical Service if the problem persists.
Fault H800E- System
Incompatible Software
Version
Call Technical Service if the problem persists.
Fault H800F- System
Memory Fault
Call Technical Service if the problem persists.
Fault H8010- System
Memory Fault
Call Technical Service if the problem persists.