Read Commands
Command Return Value Description
CP ppp ppp: Current position of the current axis in cm or
degree (Only for Height and Elevation)
TA ppp ppp: Current position of Elevations axis in degree
P? 0 oder 1
Polarisation, 0: horizontal, 1: vertical
MP ppp
ppp: Position of the Height-Axis in cm
Changes to the Height-Axis. All following commands
will relate to the Height-Axis †
BU 0 or 1
Motor Operational Status, current axis
0: Motor is off
1: Motor is on
UL
ppp: ppp: Upper limit, current axis, in cm/degree
(Only for Height and Elevation)
LL
ppp: ppp: Lower limit, current axis, in cm/degree
(Only for Height and Elevation)
SP 1 to 8
Speed of current axis. (Only for Height and Elevation)
NSP ppp
Speed of the current axis. (Only for Height and
Elevation) Height-Axis in cm/s, Elevation-Axis in
degree/s
† Height-axis is switchable between Antenna-Reference-Height and Mast-Height (see ATMH)
‡ Value is mast-height
© innco systems GmbH Schwarzenfeld/Germany
Erlenweg 12, 92521 Schwarzenfeld/Germany Phone: +49 9435 301659 0 Fax: +49 9435 301659 99
Email: info@inncosystems.com
To Next Page
Loading...