Write Commands AUTO-DISTANCE
(only TMP in combination with TMS,
commands have to be sent to TMPE or TMPM device)
Command Returns Description
LD ppp CM MD ppp Set the measurement distance to ppp cm
If AUTO-DISTANCE is switched on, then the measurement distance
will be used for the next GO command of the height axis (if possible)
Warning:
Both AUTO-TILT and AUTO-DISTANCE must be switched on, and all
values for AUTO-TILT must be set.
Alternatively the Measurement-Distance can be set in the TMS
(see ADSP)
LD iii INT AD iii Switch AUTO-DISTANCE of
LD 0 INT AD
Schaltet AUTO-DISTANCE on
LD 1 INT AD
Warning: AUTO-TILT must be switched on as well!
LD iii INT ADSP iii Switch between Measuring-Distance and Slider-Position
Switch to Measuring-Distance (default)
LD 0 INT ADSP
Switch to Slider-Position
LD 1 INT ADSP
© innco systems GmbH Schwarzenfeld/Germany
Erlenweg 12, 92521 Schwarzenfeld/Germany Phone: +49 9435 301659 0 Fax: +49 9435 301659 99
Email: info@inncosystems.com
To Next Page
Loading...