•
•
•
•
•
•
•
•
•
•
•
BV30 Mechanical Installation
Contents
Hardware Compatibility
Machine Mounting
Machine Interfacing
Power Supply
Software Compatibility
Interface Protocols
Re-programming
Machine Mounting
Mounting Points
Screw Specification
Hardware Compatibility
Machine Mounting
The BV30 is a suitable fitting replacement for the following ITL products only:
BV20
Innovative Technology Ltd. has a policy of continuous product improvement. Due to design changes older model or
product bezels may not be compatible with the BV30.
Machine Interfacing
By design the BV30 is pin to pin compatible with the suitable fitting replacement products listed above. No changes
to the machine harnessing are required.
Power Supply
It is vital that the BV30 is connected to a power supply capable of providing the required power environment. A
weak power supply causes malfunctioning of the BV30 such as note rejects or missing credits. If the BV30 is used as
a fitting replacement for an older model or product we recommend to check the power supply specifications of the
machine. The power supply of the machine might be suitable for the older model or product but not suitable for the
BV30.
Software Compatibility
Interface Protocols
When using the BV30 as a fitting replacement for an older model or product, some events such as credits may be
given faster. This is due to improved firmware routines and faster motors being used. This may cause missing
events such as credits in those host machines where timeouts are defined for the older model or product. Contact
the machine manufacturer for full compatibility of the BV30.
A weak power supply may cause malfunction
To Next Page
Loading...
