Innovative Technology BV30 - Recommended Cleaning Intervals

BV30 User Manual – 35
•
•
•
•
•
BV30 Routine Maintenance
Contents
Introduction
Recommended Cleaning Intervals
Cleaning the BV30
Clearing a Jam
Re-Initialize the Sensors
Introduction
The BV30 has been designed to minimize any performance variation over time. Much of this is achieved by careful
hardware and software design. However, depending upon the environment the BV30 may at some time require
cleaning or note path clearing.
Recommended Cleaning Intervals
Innovative Technology Ltd recommends cleaning the optical lenses every month or as required. Dirt, dust or other
residue leads to bad note acceptance and other performance degradation.
Cleaning the BV30
Disconnect the powerBEFOREcarrying out any cleaning operations to avoid the risk of causing damage to the
validator.
Do not use solvent based cleaners such as alcohol, petrol, methylated spirits, white spirit or PCB cleaner.
This will result in permanent damage to the BV30, only use a clean dry cloth or a mild detergent where
absolutely necessary.