Innovative Technology BV30 - Software Downloads

BV30 User Manual – 13
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
BV30 Software Installation and Configuration
Contents
Introduction
Software Downloads
Drivers
Dataset/Firmware Programming
Validator Manager
General Description
System Requirements
Hardware Setup
Switching to Programming Mode (SSP)
Programming the Device
DA3
General Description
System Requirements
Programming the Device
Remote Updates
Introduction
The BV30 leaves the factory pre-programmed with the latest dataset and firmware files, unless specifically
requested. However, it is important to ensure your device is kept up to date with the latest dataset and firmware.
This section will give you a brief overview of the various update possibilities with the BV30. For detailed instructions
please refer to the relevant manual package supplied with the software or contactsupport@innovative-
technology.com.
Software Downloads
All software from Innovative Technology Ltd is free of charge and can be downloaded from the websitehttp://
www.innovative-technology.com/support/secure-download once registered and logged in. If you are not
registered, please create an account via the “Create an Account” form. A confirmation email will be sent to the
registered email address once all contact details have been successfully submitted.
Drivers
The ITL drivers allow you to connect any of our validators to a compatible Windows device. If you are connecting via
an IF17 then you will not need to follow this process as they are signed Microsoft Drivers and should install
automatically. If this isn’t the case or your computer is disconnected from the network, there is a standalone
package included within the driver downloads.