•
•
•
•
•
Dataset/Firmware Programming
Validator Manager
General Description
Validator Manager is a utility which allows the user to reprogram any of ITL’s banknote and coin validators/
recyclers. Note that admin rights are required during installation. The validator must be in SSP for the Validator
Manager to detect the device.
System Requirements
Windows 8.1 and above
.Net Framework 4.5
256mb ram
50mb hard disk free
Connected BV30 with active com port
Hardware Setup
The connection example below shows how to connect the BV30 to the host machine (PC) using the IF17:
Switching to Programming Mode (SSP)
Before programming via the Validator Manager software tool, the BV30 needs to be switched to its programming
mode (SSP interface). Please refer to Switching to Programming Mode (SSP)for instructions on performing this
procedure.
We have seen instances where one of the dll’s (itdata1.dll) used in Validator Manager are flagged as a
Trojan, this is a false positive and if this happens you will need to add a rule to your antivirus to allow the
file to run.
To Next Page
Loading...
