Inovance IS580 Series - Page 110

Chapter 9 Function Code Table IS580 User Manual
- 108 -
Function
Code
Name LED Display Setting Range Min. Unit Default Property
A3-26
S-curve fall lter time of
set oil pressure
S-curve fall lter time of
set oil pressure
0.000s to 1.000s 0.001s 0.020s
☆
A3-27 Overshoot suppression
detection level
Overshoot suppression
detection
0 to 2000 1 200
☆
A3-28 Overshoot suppression
coefcient
Overshoot suppression
coefcient
0 to 3.000 0.001 0.200
☆
A3-29 Oil pressure loop gain
coefcient
Oil pressure loop gain
coefcient
0.20 to 5.00 0.01 1.00
☆
A3-30 Torque upper limit
for switchover from
pressure mode to
speed mode
Torque upper limit
for switchover from
pressure mode to speed
mode
50.0%–250.0% 0.1% 160.0%
☆
A3-31 Injection valve opening
delay
Injection valve opening
delay
0.020s to 0.500s 0.001s 0.100s
☆
A3-32 Slave min. input Slave min. input 0.0% to A3-34 0.1% 0.0%
☆
A3-33 Corresponding setting
of slave min. input
Corresponding setting
of slave min. input
-100.0% to 100.0% 0.1% 0.0%
☆
A3-34 Slave medium input Slave medium input A3-32 to A3-36 0.1% 0.0%
☆
A3-35 Corresponding setting
of slave medium input
Corresponding setting
of slave medium input
-100.0% to 100.0% 0.1% 0.0%
☆
A3-36 Slave max. input Slave max. input A3-34 to 100.0% 0.1% 100.0%
☆
A3-37 Corresponding setting
of slave max. input
Corresponding setting
of slave max. input
-100.0% to 100.0% 0.1% 100.0%
☆
A3-38 Master judges whether
to send slave speed
enabled in multi-pump
mode
Master judges whether
to send slave speed
enabled in multi-pump
mode
0: Forbid enabling the slave
speed
1: Allow enabling the slave
speed
1 0
★
A3-39 Pressure holding
control gain in multi-
pump convergent ow
Pressure holding control
gain in multi-pump
convergent ow
20 to 800 1 100
☆
A3-40 Pressure deviation for
decreasing PI to de-
twitter in multi-pump
injection mode
Pressure deviation for
decreasing PI to de-
twitter in multi-pump
injection mode
0.0 to 50.0 kg 0.1 kg 5.0 kg
☆
A3-41 Flow lower limit for
decreasing PI to de-
twitter in multi-pump
injection mode
Flow lower limit for
decreasing PI to de-
twitter in multi-pump
injection mode
0 to 30000 rpm 1 rpm 0 rpm
☆
A3-42 Flow detection time for
decreasing PI to de-
twitter in multi-pump
injection mode
Flow detection time for
decreasing PI to de-
twitter in multi-pump
injection mode
0.200s to 2.000s 0.001s 0.400s
☆