Inovance MD600 Series - Page 56

Common Parameter Settings
‑55‑
Param
eter
Code
Commu
nication
Address
Parameter Name Value Default Unit Change
Mode
F0‑10 0xF00A DI1 function
selection
0: No function
1: Terminal control IN1
2: Terminal control IN2
3: Terminal control IN3
4: Jogging 1 (JOG1)
5: Jogging 2 (JOG2)
6: Function as UP key for frequency
adjustment
7: Function as DOWN key for frequency
adjustment
8: Coast to stop
9: Fault reset (RESET)
10: Running pause (terminal control)
11:NO input of external fault
12: Multi‑reference terminal 1
13: Multi‑reference terminal 2
14: Multi‑reference terminal 3
15: Multi‑reference terminal 4
16: Terminal 1 for acceleration/
deceleration selection
17: Terminal 2 for acceleration/
deceleration selection
19: Clear data set by UP/DOWN key or by
terminal functioning as UP/DOWN key
21: Acceleration/Deceleration inhibited
22: PID pause
23: Simple PLC state reset
24: Wobble frequency pause
25:Counter input
26: Counter reset
27: Length count input
28: Length reset
29: Torque control inhibited
30: Pulse frequency input (available only
for DI4)
32: Immediate DC braking
33: NC input of external fault
34: Frequency modification
35: Opposite to PID operation direction
36: External stop terminal 1
38: PID integral pause
(To be continued)
1 ‑ At stop