Inovance Monarch NICE-L-C-4037F User Manual

Introduction
-
9
-
Function Description Remarks
Passenger
󶍾
upon fault
The system automatically determines the fault level. If the safety running
󶍾
passengers.
-
Interference
degree
judgment
The system judges the degree of communication interference.
Viewed in FA-
24
Earthquake
protection
When the earthquake detection device acts and inputs a signal to the system,
󶍿
signal becomes inactive and the fault is reset manually, the elevator restores
to normal running.
-
Current
cancellation in
ramp mode
For the PMSM, after the elevator decelerates to stop, the holding current of the
motor is canceled in ramp mode, preventing abnormal noise during current
cancellation.
F2-17
Independent
working power
supply
The NICE3000
new
system supports not only three-phase 380 VAC but also
󶍽
system (such as 220 V UPS)
-
Automatic
voltage
󶍾
The system detects the bus voltage and automatically adjusts the running
󶎀
power supply (such as emergency UPS).
-
Parallel/Group Control and Other Functions
Parallel/Group
control
The system supports parallel/group control of two elevators and provides
󶍽
-
Dispersed
waiting
󶍽󶍿 F6-09
Parallel/Group
control exit
If the parallel/group control exit switch of a certain elevator in a parallel/
group control system is valid or the time for exiting the parallel/group control
is reached, the elevator exits parallel/group control and runs independently.
󶍽
-
Parallel/
Group control
automatic exit
If an elevator in the parallel/group control system cannot respond to calls in
time due to faults, the elevator automatically exits the parallel/group control
󶍽
parallel/group control system.
-
Anti-nuisance
function
The system automatically judges the number of passengers inside the car
and car call registers. If there are excessive car calls, the system determines
that it is in nuisance state, and cancels all car calls. Then, car calls need to be
registered again correctly.
F8-08 "Anti-
nuisance
function"
Prompt of non-
door zone stop
The system gives a prompt when the elevator stops at a non-door zone area
due to faults.
-
Full-load
indication
When the elevator is full-loaded, a full-load indication is displayed on the
󶍿
-

Inovance Monarch NICE-L-C-4037F Specifications

General

Brand	Inovance
Model	Monarch NICE-L-C-4037F
Category	Controller
Language	English