6 Parameter Description
-
212
-
Function
Code
Name Setting Range Default Unit Property
F6-07
Number of
elevators in
parallel/group
mode
1 to 8 1 -
★
F6-08 Elevator No. 1 to 8 1 -
★
F6-09
Program control
selection
Bit0: Dispersed waiting
Bit2: Reserved
Bit3: Parallel/Group control
implemented at CAN2
Bit4: Group control in
compatibility with NICE3000
display direction in advance
Bit8: Unidirectional hall call
(single hall call button)
Bit9: Not detecting analog
wire breaking
Bit10: Err30 judgment at re-
leveling cancellation
Bit14: Time interval detection
of safety circuit 2 and door
lock circuit 2 (1.5s)
0 -
★
F6-07 and F6-08 are used to set the number of elevators and elevator No. in parallel/
group control mode.
see 9.14 Parallel/Group Control Scheme.
Function
Code
Name Setting Range Default Unit Property
F6-10 10 to 50 14 ms
★
F6-10 indicates the delay time from the moment when the leveling switch acts to the
moment when the leveling signal becomes active. You need not modify it.
Function
Code
Name Setting Range Default Unit Property
F6-11
Elevator function selection
2
0 to 65535 8448 -
★
F6-11 is used to select the elevator functions. If a bit is set to 1, the function indicated
by this bit is enabled; if this bit is set to 0, the function is disabled.
To Next Page
Loading...