Inovance Monarch NICE-L-C-4037F - Page 215

6 Parameter Description
-
214
-
F6-11 Elevator function selection
Bit15
Down slow-down not
reset for super short
󶍿
If this function is enabled, the down
󶍿
display. The up slow-down 1 signal still
󶍿
󶍿
function is enabled.
0
Function
Code
Name Setting Range Default Unit Property
F6-12 󶍿 0 to F6-00 0 -
★
󶍿9.9 VIP Running Function.
Function
Code
Name Setting Range Default Unit Property
F6-13 󶍿 0 to F6-00 0 -
★
󶍿
If the security signal is active or it is during the night security period, the elevator runs
󶍿󶍾
󶍿
󶍿
Fd-07/08 is set to 5 (Security signal). If the security signal is active, the elevator enters
the security state.
󶍿
security state from 22:00 p.m. to 6:00 a.m.
Function
Code
Name Setting Range Default Unit Property
F6-14
Start time of down
collective selective 1
00.00 to 23.59 00.00 HH.MM
☆
F6-15
End time of down
collective selective 1
00.00 to 23.59 00.00 HH.MM
☆
F6-16
Start time of down
collective selective 2
00.00 to 23.59 00.00 HH.MM
☆
F6-17
End time of down
collective selective 2
00.00 to 23.59 00.00 HH.MM
☆
󶍾-
tive selective 2, during which, the elevator responds to only downward hall calls.
NOTE
◆
To enable the down collective selective peak service, set FE-32 Bit6 to 1.