6 Parameter Description
-
256
-
FE-33 Elevator function selection 2
Bit Function Description Default
Bit0 Reserved - 0
Bit1
Door open holding
at open limit
The system still outputs the door open command
upon door open limit.
0
Bit2
Door close
command not
output upon door
close limit
The system stops outputting the door close
command upon door close limit.
1
Bit3 Reserved - 0
Bit4
Auto reset for RUN
and brake contactor
stuck
If the feedback of the RUN and brake contactors
is abnormal, faults E36 and E37 are reported, and
you need to manually reset the system.
With this function, the system resets automatically
after the fault symptom disappears. A maximum of
three auto reset times are supported.
0
Bit5
Slow-down switch
stuck detection
The system detects the state of slow-down
switches. Once detecting that a slow-down switch
is stuck, the system instructs the elevator to slow
down immediately and reports a corresponding
fault.
1
Bit6 Reserved - 0
Bit7 Forced door close
If the door still does not close within the time set
in Fb-17 in automatic state, the system outputs the
forced door close signal; at this moment, the light
curtain becomes invalid and the buzzer tweets.
0
Bit8 Reserved - -
Bit10
to
Bit12
Reserved - -
Bit13
High-speed elevator
protection function
A maximum allowable speed is set when the car
is in the slowdown switch position. When the
elevator exceeds the speed at the position, the
system outputs a protection signal.
0
Bit14 Reserved - 0
Bit15
Opposite door
independent control
The independent control function of the opposite
door is enabled.
0
To Next Page
Loading...