Inovance NICE900 Series - Basic Operations

Chapter 4 Operation and Trial Running
- 25 -
Key Name Function
Shift
Select the displayed parameters in turn in the stop or running state,
and select the digit to be modied when modifying parameters.
Up Increase data or function code.
Down Decrease data or function code.
OPEN
Door open Open the door in the operation panel operation mode.
CLOSE
Door close Close the door in the operation panel operation mode.
4.2 Basic Operations
4.2.1 Operation Procedure of the Operation Panel
The operation panel of the NICE900 adopts three-level menu, convenient for quick querying
and modication of parameters.
The three-level menu consists of function code group (Level I), function code (Level II), and
function code setting value (level III), as shown in the following gure.
Figure 4-2 Operation procedure on the operation panel
F0
F003
24.00
(Select the function
code group)
(Select the
function code)
(Set the value of
the function code)
Level-I menu
Level-II menu
Level-III menu
PRG
PRG
Not to save
the setting
ENTER
To save
the setting
ENTER
15.00
ENTER
Status parameter
PRG
F004
ENTER
PRG
Next function
code
(default display)
If there is a blinking digit, press
/ / to modify the digit.
You can return to Level II from Level III by pressing
PRG
or
ENTER
.
•
After you press
ENTER
, the system saves parameter setting first, and then goes back to
Level II and shifts to the next function code.
•
After you press
PRG
, the system does not save parameter setting, but directly returns to
Level II and remains at the current function code.
Here is an example of changing the value of F0-04 to 15.00 Hz.