Inovance NICE900 Series - Shift between Parameters Displayed in the Running State; Display in Stop State

Chapter 6 Description of Function Codes
- 83 -
In the running state, the display of FA-00 is a decimal value. You can press to view the
parameter indicated by each bit circularly.
Figure 6-10 Shift between parameters displayed in the running state
Shift between parameters
displayed in running state
Running frequency
Bus voltage
Output voltage
Output current
Output torque
Door position pulse
Output terminal state
Frequency reference
Input terminal state
Function Code Parameter Name Setting Range Default Min. Unit
FA-01 Display in stop state 1–63 39 1
It is used to set the parameters displayed on the operation panel when the door machine is in
the running state.
FA-00 includes 6 binary bits, each dening a parameter. A total of 6 parameters can be can be
displayed during running.
The 6 binary bits correspond to the running parameters listed in the following table.
Bit Parameter Name Default
Bit0 Frequency reference for door open 1
Bit1 Frequency reference for door close 1
Bit2 Bus voltage 1
Bit3 Input terminal state 0
Bit4 Output terminal state 0
Bit5 Door position pulse 1
The method of viewing and setting FA-01 is the same as that of FA-00.
Function Code Parameter Name Setting Range Default Min. Unit
FA-02 1st fault type 0–30 0 1
FA-03 1st fault prompt 0–9 0 1
FA-04 2nd fault type 0–30 0 1
FA-05 2nd fault prompt 0–9 0 1
FA-06 3rd fault type 0–30 0 1
FA-07 3rd fault prompt 0–9 0 1
FA-08 4th fault type 0–30 0 1
FA-09 4th fault prompt 0–9 0 1
FA-10 5th fault type 0–30 0 1