Minimate Pro Operator Manual 2–1
2. BATTERY AND MEMORY OVERVIEW
WARNING: The batteries are not intended to be replaced by the operator, and must only be
replaced by an Authorized Instantel Repair Facility. The unit should be returned to an
authorized Instantel service center for service. Any attempt to service this product will void any
and all warranties offered by Instantel. Service enquiries should be made via your dealer.
The battery used in this device may present a fire or chemical burn hazard if mistreated. Do not
disassemble or heat above 100°C (212 °F) or incinerate.
2.1. Activating the Battery
If you have received your Minimate Pro directly from Instantel, or from an Authorized
Instantel Service and Calibration Facility, the battery will be deactivated for shipping safety
and battery life conservation. Turn the battery on for use or charging by simply plugging in the
provided AC Adapter to the unit and an electrical outlet, and pressing the On/Off key. If you are
in the field or have forgotten your AC Adapter at the office, turn on the unit by pressing the Up
Arrow and Enter keys simultaneously for approximately three seconds, and then press the
On/Off key while still holding the other two keys
NOTE: A Charging Status LED is located next to the Down Arrow key and indicates the
following:
1. The light is not on – The charger is not connected to a power outlet, or the
charger is malfunctioning.
2. The light is Yellow – The charger is connected to a power outlet and is
charging.
3. The light is Green – The batteries are fully charged.
4. The light is Flashing Red/Yellow – The power source is not sufficient (i.e.
battery, solar panel, or malfunctioning charger).
2.1.1. Minimate Pro Startup
When the Minimate Pro is turned on, several information screens are displayed, as shown below:
To Next Page
Loading...