Electromagnetic Compatibility
Where applicable, this equipment is designed to comply with International Electromagnetic
Compatibility (EMC) standards.
To ensure reproduction of this EMC performance, connect this equipment to a low imped-
ance ground connection. Typical suitable connections are a ground spike or the steel frame
of a building.
Proprietary Rights Notice
This document and the information that it contains are the property of Illinois Tool Works
Inc. (ITW). Rights to duplicate or otherwise copy this document and rights to disclose the
document and the information that it contains to others and the right to use the information
contained therein may be acquired only by written permission signed by a duly authorized
officer of ITW.
Trademarks
Instron
®
is a registered trademark of Illinois Tool Works Inc. (ITW). Other names, logos,
icons and marks identifying Instron products and services referenced herein are trade-
marks of ITW and may not be used without the prior written permission of ITW.
Other product and company names listed are trademarks or trade names of their respec-
tive companies.
Original Instructions
Copyright © 2018 Illinois Tool Works Inc. All rights reserved. All of the specifications
shown in this document are subject to change without notice.
Corporate Headquarters
Instron
825 University Avenue
Norwood, MA 02062-2643
United States of America
European Headquarters
Instron
Coronation Road
High Wycombe, Bucks HP12 3SY
United Kingdom
To Next Page
Loading...
Need help?
General
