Instruo arbhar - Wavetable Mode; Wavetable Synthesis Engine and Controls

27
Wavetable Mode
Turning the Length knob fully anticlockwise forces arbhar to crossfade
into a Wavetable Synthesis Engine. The wavetable is derived from a
single-cycle loop of the captured content within the layer.
• Both Grain Direction Indicators are illuminated amber when this
mode is active.
• The pitch of the Wavetable Synthesis Engine is calibrated to
produce a C note when the Pitch knob is set to its centre position.
• The Pitch Deviation parameter functions in its normal manner.
• The Scan and Spray parameters will change the position in the layer
from which the wavetable is derived.
• The Intensity parameter changes in functionality to be an update rate
control for the wavetable content (Scan, Spray, and Pitch Deviation).
The fastest update rate is found when the Intensity knob is at its
centre position.
• Moving the Intensity knob to either of its extreme positions will
disable its continuous oscillation. In either of these extreme positions,
the Strike Button and Strike Input can be used to trigger a short note
via the Strike Granular Engine. These notes are 15 % louder than the
continuous oscillation and can be used to accentuate
continuous oscillation.