Instruo arbhar - Stereo Panning, Hold CV, and Reverb

29
• At 0V, arbhar distributes the grains in the default coin
toss method.
• With positive voltage, additional to the coin toss method, the stereo
spread is reduced. At +5V, stereo spread reduces to a fully
mono mix.
• With negative voltage, additional to the coin toss method, a random
deviation from the left and right extremes creates a more active equal
power stereo distribution. At -5V, the grains have a fully random
equal power stereo distribution.
Hold CV Configuration:
Hardware Configuration Switch Position: B-X.
Two granular engines (24 grains + 20 grains) and Wavetable Mode.
The MOD CV Input on the CV Expansion Module modulates the
Hold time
• Positive voltage increases the set Hold time.
• Negative voltage decreases the set Hold time.
Stereo Reverb Configuration:
Hardware Configuration Switch Position: B-Y.
Two granular engines (20 grains + 20 grains) and Wavetable Mode.
The MOD CV Input on the CV Expansion Module controls curated
parameters of the stereo reverb.
• Positive voltage controls reverb parameters mixed with the dry signal.
The reverb freezes at +5V.
• Negative voltage omits the dry signal and only allows the wet signal
to pass. The reverb has additional shimmering modulation.
Note: When arbhar is set to the Stereo Reverb Configuration, the
module will run at a reduced sample rate and bit depth of
48kHz / 32 Bit.