31
Save & Load
Loading a saved recording from memory after it has been erased
allows for non-destructive experimentation of recording/overdubbing
source material.
Save: To save a recording within the currently selected layer, press and
hold the Shift Button and the Capture Button and then press the Strike
Button for less than (<) 2 seconds. The Strike Button will flash indicating
that the layer has been saved to memory.
Load: To reload a saved recording after its been erased, press and hold
the Shift Button and then press the Strike Button for less than (<)
2 seconds. The Strike Button will pulse white indicating that the layer has
been loaded from memory.
Note: Save and Load refer to internal memory functions. In order to save
and load via the USB drive, please consult Import & Export section.
(Page 33).
To Next Page
Loading...