Instruo arbhar - Wavetable Synth Voice; Audio Path Setup

To Next Page

To Previous Page

Wavetable Synth Voice:

Summary: A wavetable is derived from captured audio. This

wavetable can be triggered and pitch tracked and has a variable

amplitude envelope.

Audio Path:

• Connect any audio signal to the Input.

• Set the Input Level to a desired position and set the Output Level

fully clockwise.

• Set the Dry/Wet Mix knob to a fully clockwise.

• Monitor Output 1 for mono playback.

• Set the Layer knob to the desired target layer.

Audio Signal

1V/Oct Signal

Gate Signal

for Capture

Gate Signal

for Grain Strike

Output