40
• Set the Dry/Wet Mix knob to fully clockwise. Audio will not be
heard until audio has been captured.
• Monitor Output 1 for mono playback. Monitor Output 1 and
Output 2 panned hard left and hard right for stereo playback.
• Set the Layer knob to the desired capture location.
• Press the Capture Button or connect a gate signal to the Capture
Gate Input to start capturing audio.
• Capture will be activated until the maximum layer duration has been
met, if the Capture Button is pressed while capture is activated, or if
the gate signal present at the Capture Gate Input is low.
• Once capture has deactivated, turn the Input Level fully
anticlockwise. This effectively turns down the Condenser
Microphone input signal.
• Set all granular and pitch knobs to desired positions.
Audio Path:
• Apply control voltage to any of the CV inputs of arbhar.
To Next Page
Loading...