42
• Press the Capture Button or connect a gate signal to the Capture
Gate Input to start capturing audio.
• Capture will be activated until the maximum layer duration has been
met. If the Capture Button is pressed while capture is activated, or if
the gate signal present at the Capture Gate Input is low, recording
will be stopped.
• Set the Length knob fully anticlockwise to enable Wavetable
Mode. This is indicated by two amber illuminated Grain Direction
Indicators.
• With the Intensity knob in its centre position, use the Scan knob to
set the desired wavetable.
• Once the wavetable has been chosen, set the Intensity knob either
fully clockwise or fully anticlockwise to disable the Continuous
Granular Engine.
• Set the Grain Window knob to a desired position. This will
determine the amplitude envelope.
• Set the Pitch knob to a desired position.
• Set the Pitch Deviation knob to its centre position. This ensures that
no pitch deviation is applied to the Pitch parameter.
• Set the Spray knob fully anticlockwise. This ensures that the chosen
wavetable is unaltered.
Control Path:
• Connect the 1V/Oct output of a sequencer or keyboard to the
1V/Octave Input.
• Connect the gate output of the sequencer or keyboard to the Strike
Input to activate the Strike Granular Engine.
To Next Page
Loading...