48
• Connect Output 2 to the input of a VCA for attenuated level control
of the wet signal. Set to a desired amount.
• Set the Layer knob to the desired target layer.
• Press the Capture Button or connect a gate signal to the Capture
Gate Input to start capturing audio.
• Capture will be activated until the maximum layer duration has been
met. If the Capture Button is pressed while capture is activated, or if
the gate signal present at the Capture Gate Input is low, recording
will be stopped.
• Once capture has deactivated, turn the Input Level
fully anticlockwise.
• Monitor the summed output (In the graphic above the summing is
achieved by linking two v
in
câ’s via their back jacks).
Control Path:
• Ensure the CV Expansion Module is connected to arbhar via the 12
pin IDC ribbon cable.
• Apply control voltage to the MOD CV Input to control arbhar’s
curated Feedback/Delay parameter
To Next Page
Loading...