CombiLock 200 simplex / pro / RFID
Handbuch V.1.05 66 Manual V. 1.05
7 Assembly Instructions
for CombiLock 200 simplex, - pro und CombiLock 200 RFID
Assemble and install the electronic lock and the keypad according to these
assembly instructions.
The assembly instructions are part of the VdS approval. Failure to follow these
instructions will invalidate that approval.
Uneven surfaces may cause functional loss.
Make sure that the lock is mounted to an even surface.
Applying too much force can cause damage.
Consequences which might arise from not being aware of the
danger.
Do not use more torque than 5 Nm when fastening the attachment
ring and do not use more torque than 10 Nm when fastening the
lock.
Make sure the electronic lock is protected against tampering from the
outside.
To Next Page
Loading...
