CombiLock 200 simplex / pro / RFID
Handbuch V. 1.05 61 Manual V.1.05
Optical and acoustic signal output during PIN- and CODE input
Q Red LED signal after the PIN has been
entered.
Lock is closed:
A timer program is active.
Lock has been disabled by
the master user.
Lock has been disabled by
the connected burglar alarm
system.
p 12 tone signal after the CODE has been
entered.
Invalid CODE entered.
Enter PIN and CODE again.
p 12 tone signal after the RFID-
transponder PIN has been read.
Wrong RFID transponder
RFID transponder cannot be
read.
Green LED Q flashes every second.
Open the electronic lock within
10 seconds by rotating the keypad.
5.3 Programming the RFID Release
5.3.1 Assigning a RFID Transponder to a User
Start within 10 sec. after opening:
Max. 9 RFID tags (cards or key fobs) can be programmed.
for PIN user 1 to for PIN user 9
Q CODE of the master (exemplary code)
Q Digit 1 for programming a transponder
The green LED lights up for about 10 seconds,
during which the transponder signal can be
read.
Q p
Move the RFID transponder card or the RFID
key fob close to digit 0. When the transponder
has been identified and saved, an acknowledge
signal sounds. The proper user assignment has
been saved.
To Next Page
Loading...
