68
Listening to the Radio—Continued
Setting the Satellite Radio Mode
Before you can listen to SIRIUS Satellite Radio, you
must set the “SAT Radio Mode” to “SIRIUS”.
Note:
This procedure can also be performed on the AV control-
ler by using its [Setup] button, arrow buttons, and [Enter]
button.
1
Remote
controller
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [q]/[w] but-
tons to select “7. Hardware
Setup”, and then press [Enter].
The “Hardware Setup” menu appears.
Setup
Receiver
qwer
Enter
7. Hardware Setup
1. Remote ID
2. Multi Zone
3. Tuner
4. HDMI
5. Network
6. Firmware Update
3
Use the Up and Down [q]/[w] but-
tons to select “3. Tuner”, and
then press [Enter].
The “Tuner” screen appears.
4
Use the Up and Down [q]/[w] but-
tons to select “SAT Radio Mode”,
and use the Left and Right
[e]/[r] buttons to select “SIR-
IUS”.
Pressing the Left and Right [e]/[r]
buttons cycles through the following
options: None Q SIRIUS
None: Select if you’re not using
Satellite Radio.
SIRIUS: Select to use SIRIUS Satel-
lite Radio.
5
When you’ve finished, press the
[Setup] button.
The setup menu closes.
7–3. Tuner
FM/AM Frequency Step
SAT Radio Mode
200kHz/10kHz
None
To Next Page
Loading...
