Integra DTM-5.3 - Connecting the power

16
Standby/On
Speakers
A
B
Phones
Bass
Treble Balance
L
R
Master Volume
Video
Tape 2
Monitor
Tape 1
FM
AM Phono CDDVD
Zone 2 Off
Memory
Clear
Character
Direct Tuning
FM Mode
Display
Standby
DTM
-
5.3
1 ABC 2 DEF 3 GHI
4 JKL
5 MNO 6 PQR
7 STU 8 VWX 9 YZ
-
Direct Tuning 0
/
10
/
Scan
Standby indicator
On button
Standby button
Standby/On button
Connecting the power
• Before plugging in the unit, confirm that all connections have been made properly.
• Before turning on the power, be sure that the VOLUME knob is fully turned counterclockwise.
• Turning on this unit’s power may cause a momentary power surge, which might interfere with other electrical equipment, such as comput-
ers. If so, connect the unit to a wall outlet on a different circuit.
Plug the power cord into the AC INLET, then plugging the power
cord plug into an AC outlet puts the unit in Standby mode (the
Standby indicator is lit).
Pressing the Standby/On button turns on the unit and lights up the
display. If this switch is pressed again, the unit returns to Standby
mode.
On the remote controller, press the On button to turn on the power
to the DTM-5.3, then press the Standby button to place the unit in
Standby mode.
To wall outlet