Integra DTM-5.3 - Enjoying music in the remote zone

27
Enjoying music in the remote zone
Zone 2 operation from the main room
To select a source for the zone 2 room other than the source
selected for the main room.
1 Press the Zone 2 button, the Zone 2 indicator flashes.
2 Select an input source within five seconds.
The Zone 2 indicator will light up.
Example: When the CD button is pressed.
If you want to change the source for the zone 2 room to the
same source that is selected for the main room, press the Zone 2
button again until “Z2 SRC” appears in the display.
To select the same source as that of the main room to zone 2
room.
1 Press the Zone 2 button twice while the Zone 2 indicator
is flashing (within 5 seconds).
The Zone 2 indicator will light up continuously.
Notes:
• If you set a sleep time using the Sleep button, it will also func-
tion for the zone 2 room.
• If the source for the main room is selected as the source for the
zone 2 room, and the source for the main room is changed, then
the source for the zone 2 room will change as well.
• If you select FM (or AM) using the input source buttons when
the source for the zone 2 room is set to AM (or FM), the output
for the zone 2 room also changes to AM (or FM).
• When you are using the zone 2 room, the system will not
function.
• If you are not using the Zone 2 function, press the Off button to
turn off the Zone 2 indicator.
• Even if the main room device is in Standby mode, you can
adjust the zone 2 room device settings. In this case, the display
turns off and the Zone 2 indicator flashes.
Zone 2 (A-BUS or IR) operation in the zone 2 room
1 Press the On button on the remote controller.
The power to the Zone 2 devices turned on.
2 Select an input source.
Notes:
• If you select FM or AM, use the Preset / buttons to select a
preset channel.
• Pressing the Standby button will place the Zone 2 device in
Standby mode.
Standby/On
Speakers
A
B
Phones
Bass
Treble Balance
L
R
Master Volume
Video
Tape 2
Monitor
Tape 1
FM
AM Phono CDDVD
Zone 2 Off
Memory
Clear
Character
Direct Tuning
FM Mode
Display
Standby
DTM
-
5.3
1 ABC 2 DEF 3 GHI
4 JKL
5 MNO 6 PQR
7 STU 8 VWX 9 YZ
-
Direct Tuning 0
/
10
/
Scan
Input selector buttons
Zone 2
Zone 2 indicator
Off
Zone 2
Preset
/
On, Standby
Input selector
Off
AUTAUTO
MONOMONO
AUTAUTO
MONOMONO