4
Features
■
Power output
100 watts per channel, min RMS, at 8 ohms, both
channels driven from 20 Hz to 20 kHz, with no more
than 0.08% THD
■
Discrete output stage circuits for true high-current,
low-impedance drive
■
Costly, high-quality parts such as large power transis-
tors, an oversized isolated transformer and heavy-
duty extruded heat sink make it possible to accurately
and effortlessly drive 4-ohm speakers (rare for a
receiver)
■
A-BUS Ready
■
4 Audio and 2 AV inputs
■
A-B Speaker selector and outputs
■
Video and cassette tape dubbing capability
■
Direct tone control
■
40 FM/AM random presets
■
Preset scan tuning
■
Direct access tuning
■
Motor-driven, precision volume control
■
Headphone jack
■
Audio mute, sleep timer (via remote)
■
Battery-free rotary volume knob
■
New non-resonant feet
■
New slip-free rotary volume knob
■
Compatible remote control
Supplied accessories
Check that the following accessories are supplied with the DTM-5.3.
Memory Preservation
This unit does not require memory preservation batteries. A built-in
memory power back-up system preserves the contents of the mem-
ory during power failures and even when the unit is unplugged. The
unit must be plugged in order to charge the back-up system.
The memory preservation period after the unit has been unplugged
varies depending on climate and placement of the unit. On the aver-
age, memory contents are protected over a period of a few weeks
after the last time the unit has been unplugged. This period is
shorter when the unit is exposed to a highly humid climate.
Remote controller RC-477S (1)
Batteries (AA, R6 or UM-3) (2)
Power cord (1)
AM loop antenna (1) FM indoor antenna (1)
To Next Page
Loading...
Need help?
Amplifier Section
