43
En
Name Edit
You can enter a custom name for each individual input
selector and radio preset for easy identification. When
entered, the custom name will appear on the display. The
custom name is edited using the character input screen.
■ Name
To correct a character:
Note
• To name a radio preset, use Tuner to select AM or FM, and then
select the preset.
To restore a custom name to the default, erase the custom
name by entering an empty white space for each letter.
Picture Adjust
Using Picture Adjust, you can adjust the picture quality
and reduce any noise appearing on the screen.
To view the TV picture while setting, press Enter. To
return to the previous screen, press Return.
Note
• If you are using the analog RGB input, the following settings are
not available: “Film Mode”, “Edge Enhancement”, and “Noise
Reduction”.
■ Game Mode
` Off
:
Game Mode off.
` On:
Game Mode on.
If video signal delay occurs during playback on a video
component (i.e. game console), select the corresponding
input source and set the “Game Mode” setting to “On”.
The delay will decrease but in return the picture quality
will become poor.
■ Wide Mode
*1*2
This setting determines the aspect ratio.
Note
• When the “Game Mode” is set to “On”, this setting is fixed at
“Full”.
` 4:3:
1
Use q/w/e/r to select a character, and then press
Enter.
Repeat this step to enter up to 10 characters.
2
When you’ve finished, to store a name, be sure to
use q/w/e/r to select “OK”, and then press
Enter. Otherwise it will not be saved.
BD/DVD
Shift All Erase
Shift All Erase
4 - 4. Name Edit
Name
abcde f gh i j k lm
nopqr s t uvwxyz
1234567890
–`
Space
Back Space
Shift OK
{}|: <>
?
ABCDEFGH I JKLM
NOPQRS T U VWX Y Z
;
’,
./
[]
Space
Back Space
Shift OK
!
@
#$%
^&
()_ ~
+10 CLR
+10 CLR
Name input area
Shift
*1
:
Switches the displayed character.
(Left)/ (Right):
Selected when the cursor is moved within
the Name input area.
BackSpace
*2
:
“BackSpace” moves the cursor backward
one character space. In addition, “Back-
Space” deletes the character to the left of
the cursor.
Tip
*1
You can also be performed on the remote con-
troller by using +10.
*2
Press CLR on the remote controller, you can
delete all characters in the input.
OK:
Selects when the entry is complete.
1
Use q/w/e/r to select “ ”(Left) or
“ ”(Right), and then press Enter.
2
Press Enter several times to select the incorrect
character (The cursor moves one letter each
time Enter is pressed).
3
Use q/w/e/r to select the correct character,
and then press Enter.
To Next Page
Loading...
Need help?
General
