100
Zone 2—Continued
Adjusting the Volume for Zone 2
Muting Zones
Adjusting the Tone and Balance of Zone 2
Notes:
• Only analog input sources are output by the ZONE 2
PRE OUT and Zone 2 L/R speaker terminals. Digital
input sources are not output. If no sound is heard when
an input source is selected, check if it’s connected to
an analog input.
•
While Powered Zone 2 is being used, listening modes
that need surround back speakers or front high speakers
(i.e., Dolby Digital EX, DTS-ES, and
Dolby Pro Logic
IIz Height
) are unavailable.
• While Zone 2 is on, u functions will not work.
• You cannot select different AM or FM radio stations
for your main room and Zone 2. The same AM/FM
radio station will be heard in each room. For example,
if you have an FM station for the main room, that sta-
tion will also be used in Zone 2.
• Zones can also be unmuted by adjusting the volume.
• The Zone 2 level, balance, and tone functions have no
effect on the ZONE 2 PRE OUT when the “Zone 2
Out” setting is set to “Fixed” (page 98).
Remote
controller
On the remote controller, press
the [Zone 2] button, and then use
the VOL [q]/[w] button.
AV receiver
On the AV receiver, press the
Zone 2 Level Up and Down [q]/
[w] buttons.
Remote
controller
On the remote controller, press
the [Zone 2] button, and then
press the [Muting] button.
To unmute a zone, on the remote
controller, press the [Zone 2]
button, and then press the
[Muting] button again.
1
AV receiver
On the AV receiver, press the
[Zone 2] button.
2
Press the AV receiver’s [Tone]
button repeatedly to select
“Bass”, “Treble” or “Balance”.
3
Use the Tone Plus [+] and Minus
[–] buttons to adjust the Bass,
Treble or Balance.
• You can boost or cut the Bass or Tre-
ble from –10 dB to +10 dB in 2 dB
steps.
• You can adjust the balance from 0 in
the center to +10 dB to the right or
+10 dB to the left in 2 dB steps.
,
Zone 2 Tone
DTR-30.1_En_A.book 100 ページ ２００９年４月９日 木曜日 午後１時３０分
To Next Page
Loading...
Need help?
General
