106
Controlling Other Components—Continued
Integra/Onkyo components that are connected via
u
are controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want
to control an Integra/Onkyo component that’s not con-
nected via u, use the following remote control codes:
• [DVD/BD] button
30627: Integra/Onkyo DVD player without u
(default)
•[CD] button
71817: Integra/Onkyo CD player without u
(default)
• [TV] button
11807: Integra/Onkyo TV (default)
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, use the
following remote control codes:
32900: Integra/Onkyo BD player
32901: Integra/Onkyo HD-DVD player
70868: Onkyo MD player
71323: Onkyo CD recorder
82990: Onkyo Dock
Note:
If you connect an u-capable Onkyo RI Dock to the
TV/Tape, VCR/DVR or Game jacks, for u to work
properly, you must set the Input Display accordingly
(see page 46).
You can reset a Remote Mode button to its default
remote control code.
You can reset the remote controller to its default settings.
Remote Control Codes for Integra/
Onkyo Components Connected via
u
1
Make sure the Integra/Onkyo component
is connected with an u cable and an ana-
log audio cable (RCA).
See page 38 for details.
2
Enter the appropriate remote control code
for the Remote Mode button.
•[DVD/BD] button
31612: Integra/Onkyo DVD player with u
• [CD] button
71327: Integra/Onkyo CD player with u
• [TV/Tape] button
42157: Onkyo cassette recorder with u
(default)
• [Port] button
82351: Onkyo Dock (default)
• [Tuner] button
51805: To control the AV receiver’s tuner
(default)
See the previous page for how to enter remote
control codes.
3
Press the Remote Mode button, point the
remote controller at the AV receiver, and
operate the component.
Resetting Remote Mode Buttons
1
(3 seconds)
While holding down the Remote
Mode button that you want to
reset, press and hold down the
[Audio] button until the Remote
indicator lights up (about 3 sec-
onds).
2
Within 30 seconds, press the
Remote Mode button again.
The Remote indicator flashes twice,
indicating that the button has been
reset.
Each of the Remote Mode buttons is
preprogrammed with a remote control
code. When a button is reset, its prepro-
grammed code is restored.
Resetting the Remote Controller
1
(3 seconds)
While holding down the
[Receiver] button, press and hold
down the [Audio] button until the
Remote indicator lights up
(about 3 seconds).
2
Within 30 seconds, press the
[Receiver] button again.
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.
DTR-30.1_En_A.book 106 ページ ２００９年４月９日 木曜日 午後１時３０分
To Next Page
Loading...
Need help?
General
