39
Turning On the AV Receiver
On/Standby
On/Standby
Receiver
Standby indicator
Turning On and Standby
Press the [On/Standby] button.
Alternatively, press the remote controller’s [Receiver] button, followed by
the [On/Standby] button.
The AV receiver comes on, the display lights up, and the Standby indicator goes off.
To turn the AV receiver off, press the [On/Standby] button, or press the remote control-
ler’s [On/Standby] button. The AV receiver will enter Standby mode. To prevent any
loud surprises when you turn on the AV receiver, always turn down the volume before
you turn it off.
or
ver
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.
■ Do the 2EQ Room Correction and Speaker Setup—this is
essential!
See “Audyssey 2EQ™ Room Correction and Speaker Setup” on page 47.
■ Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see “HDMI Input Setup” on page 41, “Component Video
Setup” on page 42, or “Digital Input Setup” on page 43 respectively.
■ Have you connected an Onkyo RI Dock?
If you have, see “Changing the Input Display” on page 46.
HDMI
OUT IN
TV/TAPE
RI Dock
DTR-30.1_En_A.book 39 ページ ２００９年４月９日 木曜日 午後１時３０分
To Next Page
Loading...
Need help?
General
