105
Controlling Other Components—Continued
You’ll need to enter a code for each component that you
want to control.
Note:
The remote control codes provided are correct at the time
of printing, but are subject to change.
Entering Remote Control Codes
Receiver
Display
Remote
Mode
Number
buttons
Remote
indicator
1
Look up the appropriate remote
control code in the separate
Remote Control Codes list.
The codes are organized by category
(e.g., DVD player, TV, etc.).
2
(3 seconds)
While holding down the Remote
Mode button to which you want
to enter a code, press and hold
down the [Display] button (about
3 seconds).
Notes:
• Remote control codes cannot be
entered for the [Receiver] and
[Zone 2] buttons.
• Only TV remote control codes can be
entered for the [TV] button.
• Apart from the [Receiver], [TV], and
[Zone 2] buttons, remote control
codes from any category can be
entered for the Remote Mode but-
tons. However, these buttons also
work as input selector buttons
(page 52), so choose a Remote Mode
button that corresponds with the
input to which you connect your
component. For example, if you con-
nect your CD player to the CD input,
choose the [CD] button when enter-
ing its remote control code.
3
Within 30 seconds, use the num-
ber buttons to enter the 5-digit
remote control code.
The Remote indicator flashes twice.
If the remote control code is not entered
successfully, the Remote indicator will
flash once slowly.
DTR-30.1_En_A.book 105 ページ ２００９年４月９日 木曜日 午後１時３０分
To Next Page
Loading...
