98
Zone 2—Continued
Note:
This procedure can also be performed on the AV receiver
by using its [Setup] button, arrow buttons, and [Enter]
button.
■ Zone 2 Out
If you’ve connected your Zone 2 speakers to an amp with
no volume control, set the “Zone 2 Out” setting, respec-
tively, to “Variable” so that you can set the zone’s vol-
ume, balance, and tone on the AV receiver.
■ Zone 2 Maximum Volume
With this setting, you can limit the maximum volume for
Zone 2. The Maximum Volume range is “Off”, 30 to 79.
■ Zone 2 Power On Volume
This setting determines what the volume will be for Zone
2 each time the AV receiver is turned on.
The range is “Last”, “Min”, 1 to 79 or “Max”.
To use the same volume level that was used when the AV
receiver was turned off, select “Last”.
The “Zone 2 Power On Volume” cannot be set higher
than the “Zone 2 Maximum Volume” setting.
Setting the Zone2 Out
1
Remote
controller
Press the [Receiver] button
followed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [q]/[w]
buttons to select “7. Hardware
Setup”, and then press [Enter].
The “Hardware Setup” menu appears.
3
Use the Up and Down [q]/[w]
buttons to select “Zone 2”, and
then press [Enter].
The “Zone 2” menu appears.
4
Use the Up and Down [q]/[w]
buttons to select an item, and
use the Left and Right [e]/[r]
buttons to change it.
The items are explained below.
7. Hardware Setup
1. Remote ID
2. Zone 2
3. Tuner
4. HDMI
5. Network
5
When you’ve finished, press the
[Setup] button.
The setup menu closes.
Fixed: The Zone 2 volume must be set on the amp
in that zone.
Vari able: The Zone 2 volume can be set on the AV
receiver.
DTR-30.1_En_A.book 98 ページ ２００９年４月９日 木曜日 午後１時３０分
To Next Page
Loading...
